Desværre, så sender vi ikke til dit land

se vores shipping destinationer

Send os venligst en e-mail.

Sværhedsgrad: nemt
Disse opgaver er lette for alle cykelinteresserede. Man behøver ikke værktøj, eller kun standardværktøj som unbraco nøgler, tang eller skruetrækker. I denne kategori lærer du først og fremmest, hvordan du justerer din cykel.
Downloads: Lignende emner: Print Article

Stack and Reach

Stack and Reach describes how it feels to sit on the bike. These two measurements are independent of the bike's setup such as saddle setback or seatpost length.
As stack grows, the seated position becomes more relaxed and upright (if reach stays the same).

As stack grows, the seated position becomes more stretched and sporting (if reach stays the same).

This means that the relationship of stack to reach is important. The stack to reach ratio of Canyon road bikes is essentially constant over all the frame sizes.
Bikes with the SPORT geometry: ratio above 1.55
Bikes with the SPORT PRO geometry: ratio 1.45-1.55
Bikes with the PRO geometry: ratio below 1.45

Measuring stack and reach:

Stack: centre of the bottom bracket to the top edge of the top tube, at right angles to the ground

Reach: top edge of the top tube to bottom bracket height, at right angles to the stack
Photo 1 Photo 2

Stack and reach on triathlon and time trial bikes

Then armpad stack and reach is used here: the reach is measured from the armpads. Please consult the download for the stack and reach of the Speedmax CF.

How to measure armpad stack and reach:

Stand your bike with its front wheel against a wall
Measure from the ground to the centre of the armpad: distance B+C
Measure the distance from floor to bottom bracket: distance E
Subtract the second value from the first (B+C)-E = armpad stack figure 1
Measure the distance from the bottom bracket to the wall: distance A+D
Then subtract the distance from the wall to the middle of the armpad from this (A+D)-F = armpad reach

Photo 3

Canyon søger hele tiden at sikre kvaliteten og opdatere information, der er tilgængeligt i vores Technical Support Center. Alle reparationer og justeringer du foretager på din cykel er helt på egen risiko. Hvis du er tvivl om, hvad du skal gøre. så bør du sende din cykel til Canyon eller en anden kvalificeret specialist. Canyon giver ingen garantier og kan ikke holdes ansvarlig for informationen tilgængeligt i dette Technical Support Center.


Photo 1: Stack and Reach on a roadbike

Photo 1: Stack and Reach on a roadbike

Photo 2: Stack and Reach on a MTB

Photo 2: Stack and Reach on a MTB

Photo 2: Stack and Reach on a TT bike

Photo 2: Stack and Reach on a TT bike

Hjalp denne artikel dig?janej