Desværre, så sender vi ikke til dit land

se vores shipping destinationer

Vedr. spørgsmål: Vores service center er åbent fra kl. 09:00. Du kan ringe til os på 70204011, eller sende os en e-mail.

Sværhedsgrad: svært
Disse opgaver henvender sig til erfarne og dygtige mekanikere, der har stor erfaring mht. sportscykler. Disse opgaver kræver ofte værktøj, der kræver ekspertise at bruge, så som kassette aftager, momentnøgle og pedalnøgle.
Værktøjer: Lignende emner: Print Article

Replacing of rear derailleur hanger Mountainbike

Denne artikel i dansk

The rear derailleur is the most exposed part on the bicycle. If force is applied to this part, the bike frame or the rear derailleur could be damaged. To prevent damage on these expensive parts, the rear derailleur is connected to the frame with a rear derailleur hanger. If lateral force is applied to the rear derailleur, for example by a fall or during transport, it absorbs the force and protects the frame and the rear derailleur from damage. In this case it breaks or bends.

A bent or broken rear derailleur hanger needs to be changed.

Hint: Check from time to time if the rear derailleur hanger is not bent. In many cases a bent derailleur hanger results in a malfunctioning rear derailleur.

1. Check the rear derailleur hanger as follows: Lean the bicycle on a wall and look at the hanger from behind. The cage of the rear derailleur hanger should be positioned plumb-vertical to the sprockets.
Picture 1

2. If the hanger is bent or broken, you need to change it. Firstly, unscrew the rear derailleur. Picture 2

3. The hanger is attached to the frame with two small allen screws, of either 2mm or 2,5mm.Picture 3

4. You can attach the new hanger in the same way. Always mind the correct torque. Picture 4

Apply grease to the hanger to avoid creaking sounds.

Ensure that all bolts and screws are tightened to the correct torque. The correct torque is indicated on the component itself, in the bike manual provided with your new bike, or here in the Technical Support Center.

Canyon søger hele tiden at sikre kvaliteten og opdatere information, der er tilgængeligt i vores Technical Support Center. Alle reparationer og justeringer du foretager på din cykel er helt på egen risiko. Hvis du er tvivl om, hvad du skal gøre. så bør du sende din cykel til Canyon eller en anden kvalificeret specialist. Canyon giver ingen garantier og kan ikke holdes ansvarlig for informationen tilgængeligt i dette Technical Support Center.


Picture 1: Check, if the derailleur hanger is bended

Picture 1: Check, if the derailleur hanger is bended

Picture 2: Dismantle the rear derailleur

Picture 2: Dismantle the rear derailleur

Picture 3: Undo the screw

Picture 3: Undo the screw

Picture 4: Tighten the screw

Picture 4: Tighten the screw

Hjalp denne artikel dig?janej