Desværre, så sender vi ikke til dit land

se vores shipping destinationer

Vores service center er åbent igen i morgen kl. 09:00. Send os venligst en e-mail.

Sværhedsgrad: - Lignende emner:
Print Article

Compatibility of suspension forks

If you want to fit a new fork to your bike, then you should pay attention to the following:

• Equal travel
• Equal total length (+-5mm). The total length is measured from the middle of the quick release to the top edge of fork crown. Bild 1

• Equal fork shaft length
• Only the Torque FRX is approved for use with double fork crowns.
• Please note the different standards for brake mounts. It may be necessary to purchase the relevant adapter.
• Please note the maximum brake disc diameters for suspension forks.
• The suitable hub with the correct axle retainer (thru-axle 15mm, 20mm and quick release axle)
Please note that many Canyon bikes are fitted with tapered shafts. If you decide to fit a fork with an untapered shaft, you’ll need another head set with a relevant diameter.
The Yellowstone and Lux MR series don’t have tapered fork shafts. The Torque has an end-to-end 1.5 inch diameter.

Canyon søger hele tiden at sikre kvaliteten og opdatere information, der er tilgængeligt i vores Technical Support Center. Alle reparationer og justeringer du foretager på din cykel er helt på egen risiko. Hvis du er tvivl om, hvad du skal gøre. så bør du sende din cykel til Canyon eller en anden kvalificeret specialist. Canyon giver ingen garantier og kan ikke holdes ansvarlig for informationen tilgængeligt i dette Technical Support Center.


Hjalp denne artikel dig?janej