Unfortunately, we do not ship to your country.
see our shipping destinations
- Change of cassette Mountainbike
- Change chain Mountainbike
- Replacing of rear derailleur hanger Mountainbike
- Compatibility of disc brakes
- Exchange and copatibility of dampers
- Routing of brake cable mountainbike
- Replace supension fork
- Dismantle Fox damper
- Replacing of Shimano HT II roadbike bottom bracket
- Assembly of headset parts
1
2
Exchange and copatibility of dampers
In principle, it is possible to exchange the shock on every Canyon mountain bike. The new shock must have the same compression length and the same fitting length as the old one. The bushing size for all Canyon bikes is M8.
The fitting length of the shock is measured from the exact center of each of the shock eyes.
If you do decide to change your shock, then you will require new bushings from the relevant shock manufacturer.
The Nerve bushing size is M8x35.0mm.
If the damper has a piggy back make sure that the piggy back does not touch the frame or any other part of the bicycle under no matter how far the damper is deflected.
Canyon consistently strives to ensure the quality and accuracy of the information contained in this Technical Support Center. Any repairs or adjustments which you carry out on your bike are entirely at your own risk. If you are in any doubt about what to do, you should send your bike to Canyon or take it to another qualified repair specialist. Canyon gives no guarantee or accepts no liability for the any of the information contained in this Technical Support Center.
