Unfortunately, we do not ship to your country.

SERVICE CHAT TALK TO THE PEOPLE THAT BUILD YOUR BIKE:

CHAT IS NOT AVAILABLE RIGHT NOW. WE WILL BE BACK ONLINE SOON.

Onze servicedesk is vandaag vanaf 09:00 uur bereikbaar. Je kunt ons bereiken op 030 888 1415 of stuur ons een e-mail
Moeilijkheid: Eenvoudig
Deze ingrepen zijn eenvoudig voor iedereen met interesse in fietsen. Voor deze workshop heb je geen gereedschap nodig, of slechts een inbussleutel, tangetje of schroevendraaier. In deze categorie vind je vooral hoe je aanpassingen moet doen op je fiets.
Tools: Gelijke onderwerpen: Print artikel

Special Features of Bicycles with Reverb Stealth

Bikes which are fitted with the Reverb Stealth may sometimes be delivered in the Bike Guard with the right-hand brake lever and remote lever removed.

This is how you fit these parts:

1. Apply friction paste inside the seat tube. Place the seat post in the frame and close the quick release. Picture1 The seat post must be inserted inside the frame at least as far down as the lower edge of the top tube. The quick release must not be over tightened, but you should also not be able to turn it in the frame.

2. Put the Torx-Bit onto the Canyon Torque Wrench as shown. Picture2

3. Bikes fitted with a simple bracket: Position the bracket around the handlebar and tighten the fixing bolt/screw to 4Nm as shown. Picture 3 Picture 4

4. Matchmaker brackets have two bolts/screws. Assemble the Reverb remote lever and the brake lever. First tighten the front bolt/screw to 4Nm as shown in image 5 and then the rear bolt/screw also to 4Nm. Picture 5

5. The line for the right-hand brake lever runs ahead of all the other cables in front of the handlebar and into the frame on the left side of the down tube. The line for the remote lever runs closest to the head tube before it enters the down tube.

If your Reverb seat post no longer delivers optimum function, check that the seat clamp is fitted correctly. The seat clamp should be tightened so that you can’t turn the seat post inside the frame.

Apply friction paste inside the seat tube before assembling the Reverb. Never use grease when assembling the Reverb seatpost.

Never bleed the Reverb or Reverb Stealth seat post yourself. This work should be carried out exclusively by a competent mechanic. This also applies to any required air pressure adjustments.

Picture 6


Canyon streeft voortdurend naar behoud van kwaliteit en nauwkeurigheid van de informatie die zich bevindt in het Technical Support Center. Reparaties of aanpassingen die je aan je eigen fiets doet zijn volledig op eigen risico. Als je twijfelt over wat te doen, kun je het beste contact op nemen met het Canyon Servicecentrum. Canyon geeft geen garantie en accepteert geen aansprakelijkheid voor de informatie die zich bevindt in het Technical Support Center.


Picture 1: Mount the Seatpost

Picture 1: Mount the Seatpost

Picture 2: Torque Wrench with Bit

Picture 2: Torque Wrench with Bit

Picture 3: Position the bracket around the handlebar

Picture 3: Position the bracket around the handlebar

Picture 4: Tighten the screw with the correct torque

Picture 4: Tighten the screw with the correct torque

Picture 5: Mounting of Matchmaker

Picture 5: Mounting of Matchmaker

Picture 6: Matchmaker Clamps

Picture 6: Matchmaker Clamps

Was dit artikel nuttig?JaNee

Pure Cycling.