Unfortunately, we do not ship to your country.

Vårt servicecenter öppnar igen imorgon kl 09:00. Skicka gärna ett mail.
Svårighetsgrad: svår
Dessa workshops är till för den erfarna och kunniga mekanikern som har stor erfarenhet av sportcyklar. Arbeten i denna kategori kräver kunskap om speciella verktyg såsom kedjepiska, momentnyckel och pedalnyckel.
Verktyg: Liknande ämnen: Skriv ut artikel

Replace Formula Brake Pads

Changing Formula The One and RX brake pads

1. Remove the wheel.

2. You slacken the fixing bolt of the R1 with a TorxT15. With the RX and The One you take off the safety bolt and slacken the screw with an Allen key.

3. Now you can pull out the brake pads by hand.

4. Clean the inside of the caliper with a clean cloth and brake cleaner / isopropyl alcohol.

5. Slide the worn pads back into the caliper. Then prize apart the brake piston with a slotted screw driver or bleed block.

6. Pull the worn pads out of the brake caliper.

7. Wipe off any excess lubricant or grease.

8. Push the new brake pads into the brake caliper. The pads are identical on both sides therefore it does not matter on which side you fit them.

9. Check if the safety bolt is undamaged. If it is damaged it must be replaced.

10. Secure the brake pad with the safety screw and bolt. Then tighten both to 2Nm (+-5%).

11. Insert the wheel. Ensure that the brake disc is central and runs through the brake pads without catching on them. It may be that you need to adjust the brake caliper.

12. Before full braking performance can be achieved, the brake has to be „ridden in“. Carry out several braking tests before you make full use of the braking system. Apply the brakes gently at low speeds and off main roads. The brakes should not be overloaded on long downhill rides until they have been used for at least 200km.

All brake components must be clean and free from grease and oil. Never apply copper paste on a bike.

Wear safety gloves and goggles while working on the bicycle.

Always mind the correct torque value. Only use original parts.

Always mind the information and instructions given by the manufacturers.

Never use the bicycle without brake pads.

Ensure that all bolts and screws are tightened to the correct torque. The correct torque is indicated on the component itself, in the bike manual provided with your new bike, or here in the Technical Support Center.

Canyon jobbar hårt för att informationen här i teknisk support ska vara så korrekt och uppdaterad som möjligt. Dock sker alla reparationer som du gör själv på egen risk. Skulle du vara tveksam över något så ska du skicka in cykeln till oss eller en kvalificerad mekaniker/cykelverkstad. Canyon tar inget ansvar och ger ingen garanti på att informationen här i teknisk support är korrekt.

Hjälpte denna artikel dig?janej

Pure Cycling.