Unfortunately, we do not ship to your country.

SERVICE CHAT TALK TO THE PEOPLE THAT BUILD YOUR BIKE:

CHAT IS NOT AVAILABLE RIGHT NOW. WE WILL BE BACK ONLINE SOON.

Vi är åter tillgängliga mndag 09:00. Skicka oss ett e-mail.
Svårighetsgrad: Lätt
Dessa arbeten är enkla för den som är intresserad av cykling. För den här workshopen krävs inga speciella verktyg utan det räcker med standardverktyg som insexnycklar, tänger eller skruvmejslar. Här hittar du all information om hur du justerar din cykel.

Verktyg: Liknande ämnen: Skriv ut artikel

Special Features of Bicycles with Reverb Stealth

Bikes which are fitted with the Reverb Stealth may sometimes be delivered in the Bike Guard with the right-hand brake lever and remote lever removed.

This is how you fit these parts:

1. Apply friction paste inside the seat tube. Place the seat post in the frame and close the quick release. Picture1 The seat post must be inserted inside the frame at least as far down as the lower edge of the top tube. The quick release must not be over tightened, but you should also not be able to turn it in the frame.

2. Put the Torx-Bit onto the Canyon Torque Wrench as shown. Picture2

3. Bikes fitted with a simple bracket: Position the bracket around the handlebar and tighten the fixing bolt/screw to 4Nm as shown. Picture 3 Picture 4

4. Matchmaker brackets have two bolts/screws. Assemble the Reverb remote lever and the brake lever. First tighten the front bolt/screw to 4Nm as shown in image 5 and then the rear bolt/screw also to 4Nm. Picture 5

5. The line for the right-hand brake lever runs ahead of all the other cables in front of the handlebar and into the frame on the left side of the down tube. The line for the remote lever runs closest to the head tube before it enters the down tube.

If your Reverb seat post no longer delivers optimum function, check that the seat clamp is fitted correctly. The seat clamp should be tightened so that you can’t turn the seat post inside the frame.

Apply friction paste inside the seat tube before assembling the Reverb. Never use grease when assembling the Reverb seatpost.

Never bleed the Reverb or Reverb Stealth seat post yourself. This work should be carried out exclusively by a competent mechanic. This also applies to any required air pressure adjustments.

Picture 6


Canyon jobbar hårt för att informationen här i teknisk support ska vara så korrekt och uppdaterad som möjligt. Dock sker alla reparationer som du gör själv på egen risk. Skulle du vara tveksam över något så ska du skicka in cykeln till oss eller en kvalificerad mekaniker/cykelverkstad. Canyon tar inget ansvar och ger ingen garanti på att informationen här i teknisk support är korrekt.


Picture 1: Mount the Seatpost

Picture 1: Mount the Seatpost

Picture 2: Torque Wrench with Bit

Picture 2: Torque Wrench with Bit

Picture 3: Position the bracket around the handlebar

Picture 3: Position the bracket around the handlebar

Picture 4: Tighten the screw with the correct torque

Picture 4: Tighten the screw with the correct torque

Picture 5: Mounting of Matchmaker

Picture 5: Mounting of Matchmaker

Picture 6: Matchmaker Clamps

Picture 6: Matchmaker Clamps

Hjälpte denna artikel dig?JaNej

Pure Cycling.