Unfortunately, we do not ship to your country.

Se till vilka länder vi sänder

Vi är åter tillgängliga mndag 09:00. Skicka oss ett e-mail.

Svårighetsgrad: lätt
Dessa arbeten är enkla för den som är intresserad av cykling. För den här workshopen krävs inga speciella verktyg utan det räcker med standardverktyg som insexnycklar, tänger eller skruvmejslar. Här hittar du all information om hur du justerar din cykel.

Verktyg: Liknande ämnen: Skriv ut artikel

Pack bike into Bike Shuttle

You can transport your bike conveniently and safely using the Canyon BikeShuttle:


1. Remove the pedals using a 15mm spanner or a 6mm or 8mm Allen Key, depending on pedal manufacturer. Please note that the non drive-side pedal has an opposite or “left-hand” thread. To remove this pedal turn it clockwise. The drive side is a standard thread

2. Deflate both tyres and remove the front wheel from the fork.

3. Remove the quick release from the wheel and place it in one of the pockets of the WheelGuard bags.

4. Now remove the rear wheel and again place the quick release into the WheelGuard pocket.

TIP: Before removing the rear wheel, put the chain into the large chainring at the front and the smallest sprocket of the cassette. This will make it easier to remove the wheel.

5. Release the seat clamp and remove the seat post together with the saddle.

6. Now dismantle the handlebar from the stem by untightening the bolts of the stem face plate. TIP: Wrap handlebar in protective plastic fix the handlebar to the top tube using cable ties.
Attention: Be careful to turn the handlebar as little as possible to prevent damage to the gear cables and brake lines.
7. Reassemble the stem face plate so you don’t lose the bolts.

8. Now place the entire bike into the case as shown in the images. If the bike doesn’t fit remove the rear derailleur or turn the stem 180°on the fork steerer.

9. Place the wheels into the WheelGuard bags and lay the bags on top of the frame.

10. Now place the seat post in the BikeShuttle, ensuring that it cannot scrape the paintwork of the frame. Wrap the seat post or frame tube up in protective plastic if neccesary.

11. Close the BikeShuttle and click-close the hinges.

Hinweis: Bei Rennrädern Größe 64cm muss zusätzlich die Gabel ausgebaut werden, damit das Bike in des Bike Shuttle passt.

Weights and dimensions BikeShuttle:

Exterior dimensions:

Deepth: 30cm | Height: 85cm

Top length: 84cm | Bottom length: 118cm

Weight Approx. 14.8 kg including Wheel Guard bags and foam mats

Inner dimensions:

Deepth: 25cm | Heighth: 83,5cm
Top length: 83cm | Bottom length: 112cm


Canyon jobbar hårt för att informationen här i teknisk support ska vara så korrekt och uppdaterad som möjligt. Dock sker alla reparationer som du gör själv på egen risk. Skulle du vara tveksam över något så ska du skicka in cykeln till oss eller en kvalificerad mekaniker/cykelverkstad. Canyon tar inget ansvar och ger ingen garanti på att informationen här i teknisk support är korrekt.


Picture 1:Attach the cap of the stem losely

Picture 1:Attach the cap of the stem losely

Picture 2: Attach the handlebarto the upper tube

Picture 2: Attach the handlebarto the upper tube

Picture 3: Place the frame inside the Shuttle

Picture 3: Place the frame inside the Shuttle

Picture 4: Add the wheels and the seatpost then

Picture 4: Add the wheels and the seatpost then

Hjälpte denna artikel dig?janej