Unfortunately, we do not ship to your country.

Se till vilka länder vi sänder

Vårt servicenter öppnar idag kl 09:00. Du kan nå oss på 0767 - 650 596 eller skicka oss epost.

Svårighetsgrad: - Liknande ämnen: Skriv ut artikel

Correct use of cleats

Since click pedals were invented several different systems have been able to establish themselves. Due to these different standards when you purchase new cycling shoes there are normally no cleats supplied. These are supplied when you buy a new pair of pedals. The cleat forms a link between the shoe and the pedal. On the majority of pedals it is also possible to adjust the release tension.

The thread insert is part of the shoe itself. Grease the thread before fitting the cleats and tighten the cleat bolts after the first ride. Please observe the torque recommended by the shoe manufacturer when tightening.

The cleat is the link between the shoe and the pedal. Depending on the pedal system you have you must either twist your foot outwards or to the rear to “get out of the pedals”.

The most conventional click pedal systems are:

:

Shimano SPD:

Pedal system for mountain bikes from Shimano

Shimano SPD-R:

Pedal system for road bikes from Shimano

SPD-SL:

Road bike system from Shimano with a wider contact surfaceBild 1

Time:

Manufacturer of road and mountain bike click pedal systems

Look:

Developed the first click pedal system for bikes in 1984 which was based on systems from skis.

Crank Brothers:

Manufacturer of the dirt resistant Egg Beater click pedal system

Please observe the following:


• Cleats wear out relatively quickly and must be regularly replaced.
• Cleats can cause noises. Assembly grease can remedy such problems.
• Use only the cleats supplied with your new shoes by the manufacturer.

Ensure that all screws and bolts are tightened to the correct torque. The correct torque is indicated on the component itself, in the bike manual provided with your new bike, or here in the Technical Support Center.


Canyon jobbar hårt för att informationen här i teknisk support ska vara så korrekt och uppdaterad som möjligt. Dock sker alla reparationer som du gör själv på egen risk. Skulle du vara tveksam över något så ska du skicka in cykeln till oss eller en kvalificerad mekaniker/cykelverkstad. Canyon tar inget ansvar och ger ingen garanti på att informationen här i teknisk support är korrekt.


Picture 1: Shimano SPD-SL pedals

Picture 1: Shimano SPD-SL pedals

Hjälpte denna artikel dig?janej