Unfortunately, we do not ship to your country.

SERVICE CHAT TALK TO THE PEOPLE THAT BUILD YOUR BIKE:

CHAT IS NOT AVAILABLE RIGHT NOW. WE WILL BE BACK ONLINE SOON.

Vårt servicecenter öppnar igen imorgon kl 09:00. Skicka gärna ett mail.
Svårighetsgrad: svår
Dessa workshops är till för den erfarna och kunniga mekanikern som har stor erfarenhet av sportcyklar. Arbeten i denna kategori kräver kunskap om speciella verktyg såsom kedjepiska, momentnyckel och pedalnyckel.
Verktyg: Liknande ämnen: Skriv ut artikel

Replacing of rear derailleur hanger Roadbike

The rear derailleur is the most exposed part on the bicycle. If excessive force is applied on this part, the bike frame or the rear derailleur could be damaged. To prevent damage on these expensive parts, the rear derailleur is connected to the frame with a rear derailleur hanger. If lateral force is applied to the rear derailleur, for example by a fall or while in transport, it absorbs the force and protects the frame and the rear derailleur from damage. In this case it breaks or bends.

A bent or broken rear derailleur hanger needs to be replaced.

Hint: Check from time to time if the rear derailleur hanger is not bent. In many cases a bent derailleur hanger results in a malfunctioning rear derailleur.

1. Check the rear derailleur hanger as follows: Lean the bicycle on a wall and look at the hanger from behind. The cage of the rear derailleur hanger should be positioned plumb-vertical to the sprockets.
Picture 1

2. If the hanger is bent or broken, you’ll need to change it. Firstly, unscrew the rear derailleur. Picture 2

3. The hanger is attached to the frame with two small allen screws, of either 2mm or 2,5mm. Picture 3

4. You can attach the new hanger in the same way. Always mind the correct torque. Picture 4

Apply grease to the hanger to avoid creaking sounds.

Ensure that all bolts and screws are tightened to the correct torque. The correct torque is indicated on the component itself, in the bike manual provided with your new bike, or here in the Technical Support Center.


Canyon jobbar hårt för att informationen här i teknisk support ska vara så korrekt och uppdaterad som möjligt. Dock sker alla reparationer som du gör själv på egen risk. Skulle du vara tveksam över något så ska du skicka in cykeln till oss eller en kvalificerad mekaniker/cykelverkstad. Canyon tar inget ansvar och ger ingen garanti på att informationen här i teknisk support är korrekt.


Picture 1: Check, if the derailleur hanger is bended

Picture 1: Check, if the derailleur hanger is bended

Picture 2: Dismantle the rear derailleur

Picture 2: Dismantle the rear derailleur

Picture 3: Undo the screw

Picture 3: Undo the screw

Picture 4: Tighten the screw

Picture 4: Tighten the screw

Hjälpte denna artikel dig?janej

Pure Cycling.