Bohužiaľ, nezasielame do tejto destinácie.prehľad štátov kam zasielame
Prosím kontaktujte nás. Jsme k dispozici dnes do 16:30: +421 220 510 450
We recommend to tighten Canyon seat clamps with -Nm to 5Nm. The maximum torque value for Canyon seat clamps is 7Nm
The torque should be as low as possible but the seatpost must not slip under great force. The seatpost clamp must be tightened so that it can not be turned around its axis.
When fitting Canyon carbon seat posts apply carbon paste generously to the inside of the seat tube and to also to the seat post itself.
When fitting alloy seat posts apply grease to both the seat post and the inside of the seat tube.
Please note: do not tighten the seat clamp too much when you ride a variabel seat post, like the Reverb. Otherwise it might be possible that you can not adjust the post any more. Please take extra care that the seat post must never slight into the seat tube.
Torque for Speedmax CF frame clamp for seatpost: 4Nm, maximum 6Nm. Please take care that the clamping brackets are free from glue.
Check that all screws and bolts have the correct tightening torque. You will find the correct figures on the components themselves, in the Operating Manual or here in the Support Centre. Steel suspension forks are held together in transit with a tensioning belt, which should only be used for transport.