- Strive CF
- Strive AL
- Spectral CF
- Spectral AL 29
- Spectral AL
- Nerve AL 29
- Nerve AL
- Lux CF 29
- Grand Canyon CF SLX 29
- Grand Canyon CF SL 29
- Grand Canyon CF 29
- Grand Canyon AL SLX 29
- Grand Canyon AL 29
- Yellowstone AL 29
- Dude CF
Bohužiaľ, nezasielame do tejto destinácie.
ONLINE CHAT SPÝTAJTE SA NAŠICH ODBORNÍKOV:
CHAT NIE JE MOMENTÁLNE DOSTUPNÝ. ČOSKORO BUDEME OPÄŤ ONLINE.
This standard is used by the majority of manufacturers. The brake disc is fixed to the hub body by six bolts.
This standard is used by Avid and Shimano. The brake disc is fixed at its centre to the hub. The brake disc is pushed onto a cog and then tightened up using a lock ring. By using an adapter you can use Centerlock hubs with six-hole fixing.
6“ (160mm), 7“ (185mm) 8“ (203mm)
Normally used by Avid.
160mm, 180mm, 203mm
Normally used by Formula, Magura and Shimano
You can use larger brake discs with both American and European sizes if you fit an appropriate adapter. If you opt to use an adapter, one speaks of the so-called Postmount. If the caliper is fitted without an adapter, one speaks of the so-called Direct Mount.
6" Postmount: Nerve series, Lux CF 29", Grand Canyon AL and CF series
7" Postmount: Spectral AL, New Torque series 2010, Torque EX and DHX, Strive series, Torque FRX Serie from 2012
IS2000: Inlite AL, Lux MR, Torque ES and FRX series until 2011, Stitched series and Yellowstone series
Larger brake discs can also be fitted to the suspension fork with both American and European sizes.
Attention:Ensure when fitting that the fork is approved for use with the relevant brake disc diameter. Failure to do so could result in damage to the fork!
Our bikes are approved for use only with brake disc diameters which are factory fitted.
upto 203mm, 6“ Postmount
upto 205mm, 6“ Postmount
from 200mm to 225mm, special IS2000 for 8“
210mm, 8“ Postmount
upto 210mm, Durin have 6“ Postmount
upto 210mm, 8” Postmount
upto 210mm, 6” Postmount
upto 160mm, 6“ Postmount
upto 185mm, IS2000
These values are recommended if not other values are given either in the manuals of the manufacturers or printet on the bicycle part. Always mind the instructions of the manufacturers for dismantling and detaching of brakes. Ensure that all screws and bolts are tightened to the correct torque. The correct torque is indicated on the component itself, in the bike manual provided with your new bike, or here in the Technical Support Center.