How to install and adjust the CP0018 aero cockpit
Watch the full how-to unboxing video





How to install the CP0018 aero cockpit
For this part, keep the bike lying sideways on the box. Before you start, take out the small cardboard toolbox from the bike box, and open it.
You’ll need the Canyon torque wrench in there for the next steps.
2.1 Slide the insert down into the headset. Check that the insert is the right way up as pictured.
2.2 Take your carbon paste from the toolbox, apply it onto the steerer tube, and slide the cockpit down over the steerer tube.
2.3 Slide top cap down onto the headset.
2.4 Tighten top cap to the correct Nm number (printed on the top cap).

How to adjust handlebar width





How to adjust cockpit height





How to collapse the cockpit for travel





How to pack the Aeroad





Previous: Aeroad CFR and CF SLX 2021 bike build instructions
Disclaimer of Liability
Canyon consistently strives to ensure the quality and accuracy of the information contained in this Technical Support Centre. Any repairs or adjustments which you carry out on your bike are entirely at your own risk. If you are in any doubt what to do, you should send your bike to Canyon or take it to another qualified specialist. Canyon gives no guarantee or accepts no liability for any of the information contained in this Technical Support Centre.
Content is loading