Desværre, så sender vi ikke til dit land

se vores shipping destinationer

Vedr. spørgsmål, kontakt venligst vores service center. Vi er på telefonen til kl. 16:00. 70204011

Difficulty: - Similar Topics:
Print Article

Assembly of headset parts

Denne artikel i dansk

Ensure when fitting the headset that you follow the correct procedure and positioning of each part.

Please see photos (right) on how to do this:

Picture 1
Picture 2
Picture 3
Picture 4

The lower most bearing cone is part of the fork must not be removed!

Always mind the manuals of the manufacturers. Ensure that all bolts and screws are tightened to the correct torque. The correct torque is indicated on the component itself, in the bike manual provided with your new bike, or here in the Technical Support Center.

Do not try to remove the bottom cone ring.


Canyon consistently strives to ensure the quality and accuracy of the information contained in this Technical Support Center. Any repairs or adjustments which you carry out on your bike are entirely at your own risk. If you are in any doubt about what to do, you should send your bike to Canyon or take it to another qualified repair specialist. Canyon gives no guarantee or accepts no liability for the any of the information contained in this Technical Support Center.

Picture 1: Acros Aix headset

Picture 1: Acros Aix headset

Picture 2: i-Lock headset

Picture 2: i-Lock headset

Picture 3: IPU headset until 2012

Picture 3: IPU headset until 2012

Picture 4: Current IPU Headset from 2013

Picture 4: Current IPU Headset from 2013

Did this article help you?yesno