Desværre, så sender vi ikke til dit landse vores shipping destinationer
If the cassette needs to be removed, for example to clean parts or to remove the sprocket protector follow these simple instructions:
1. Remove the rear wheel from the frame and the quick release from the wheel. Fit the cassette tool into the axle and wrap the chain whip around the largest or second largest sprocket ring. The chain whip needs be mounted in the direct that will prevent the freehub from turning anti clockwise while removing the cassette.
2. Using a suitable spanner on the cassette tool undo the lockring whilst at the same time holding against the chain whip. You can now slide the cassette off the free hub.
3. To reattach the cassette you don’t need to use the chain whip. Apply a light film of grease to the freehub and slide the cassette back on in the correct order. Check that all the spacers are positioned correctly. Now screw the lockring onto the thread of the freehub being careful not cross thread either part. Tighten the lockring using the cassette tool and a torque wrench to the specified 40 Nm.
Ensure that all screws and bolts are tightened to the correct torque. The correct torque is indicated on the component itself, in the bike manual provided with your new bike, or here in the Technical Support Center.