Unfortunately, we do not ship to your country.see our shipping destinations
Our Servicecenter is available again tomorrow from 08:00. Send us an e-mail.
The rear derailleur is the most exposed part on the bicycle. If excessive force is applied on this part, the bike frame or the rear derailleur could be damaged. To prevent damage on these expensive parts, the rear derailleur is connected to the frame with a rear derailleur hanger. If lateral force is applied to the rear derailleur, for example by a fall or while in transport, it absorbs the force and protects the frame and the rear derailleur from damage. In this case it breaks or bends.
A bent or broken rear derailleur hanger needs to be replaced.
Hint: Check from time to time if the rear derailleur hanger is not bent. In many cases a bent derailleur hanger results in a malfunctioning rear derailleur.
1. Check the rear derailleur hanger as follows: Lean the bicycle on a wall and look at the hanger from behind. The cage of the rear derailleur hanger should be positioned plumb-vertical to the sprockets.
2. If the hanger is bent or broken, you’ll need to change it. Firstly, unscrew the rear derailleur. Picture 2
3. The hanger is attached to the frame with two small allen screws, of either 2mm or 2,5mm. Picture 3
4. You can attach the new hanger in the same way.Picture 4
Apply grease to the hanger to avoid creaking sounds.
Ensure that all bolts and screws are tightened to the correct torque. The correct torque is indicated on the component itself, in the bike manual provided with your new bike, or here in the Technical Support Center.