Sfortunatamente non spediamo nel tuo paese.

Trova subito la tua risposta qui. Il nostro Servizio Tecnico è disponibile di nuovo domani dalle 09:00. Scrivici.
Difficoltà: Facile
Questo tipo di lavori è semplice per chiunque sia interessato al ciclismo. Per queste attività di officina non è necessario nessun attrezzo, oppure bastano chiavi semplici come quelle inglesi, cacciaviti o pinze. In questa sezione trovi come eseguire le regolazioni sulla tua bici.
Attrezzi: Discussioni simili: Articoli da stampare

Special Features of Bicycles with Reverb Stealth

Bikes which are fitted with the Reverb Stealth may sometimes be delivered in the Bike Guard with the right-hand brake lever and remote lever removed.

This is how you fit these parts:

1. Apply friction paste inside the seat tube. Place the seat post in the frame and close the quick release. Picture1 The seat post must be inserted inside the frame at least as far down as the lower edge of the top tube. The quick release must not be over tightened, but you should also not be able to turn it in the frame.

2. Put the Torx-Bit onto the Canyon Torque Wrench as shown. Picture2

3. Bikes fitted with a simple bracket: Position the bracket around the handlebar and tighten the fixing bolt/screw to 4Nm as shown. Picture 3 Picture 4

4. Matchmaker brackets have two bolts/screws. Assemble the Reverb remote lever and the brake lever. First tighten the front bolt/screw to 4Nm as shown in image 5 and then the rear bolt/screw also to 4Nm. Picture 5

5. The line for the right-hand brake lever runs ahead of all the other cables in front of the handlebar and into the frame on the left side of the down tube. The line for the remote lever runs closest to the head tube before it enters the down tube.

If your Reverb seat post no longer delivers optimum function, check that the seat clamp is fitted correctly. The seat clamp should be tightened so that you can’t turn the seat post inside the frame.

Apply friction paste inside the seat tube before assembling the Reverb. Never use grease when assembling the Reverb seatpost.

Never bleed the Reverb or Reverb Stealth seat post yourself. This work should be carried out exclusively by a competent mechanic. This also applies to any required air pressure adjustments.

Picture 6

Canyon si impegna costantemente per garantire la qualità e la completezza delle informazioni contenute nel Technical Support Center. Ogni riparazione o regolazione che esegui sulla tua bici è interamente a tuo rischio e pericolo. Se non ti senti sicuro in quello che fai, invia la tua bici a Canyono rivolgiti ad un meccanico specializzato. Canyon non da garanzie e non accetta reclami per qualsiasi informazione contenuta nel Technical Support Center

Picture 1: Mount the Seatpost

Picture 1: Mount the Seatpost

Picture 2: Torque Wrench with Bit

Picture 2: Torque Wrench with Bit

Picture 3: Position the bracket around the handlebar

Picture 3: Position the bracket around the handlebar

Picture 4: Tighten the screw with the correct torque

Picture 4: Tighten the screw with the correct torque

Picture 5: Mounting of Matchmaker

Picture 5: Mounting of Matchmaker

Picture 6: Matchmaker Clamps

Picture 6: Matchmaker Clamps

Questo articolo è stato utile?SiNo

Pure Cycling.