Since click pedals were invented several different systems have been able to establish themselves. Due to these different standards when you purchase new cycling shoes there are normally no cleats supplied. These are supplied when you buy a new pair of pedals. The cleat forms a link between the shoe and the pedal. On the majority of pedals it is also possible to adjust the release tension.
The thread insert is part of the shoe itself. Grease the thread before fitting the cleats and tighten the cleat bolts after the first ride. Please observe the torque recommended by the shoe manufacturer when tightening.
The cleat is the link between the shoe and the pedal. Depending on the pedal system you have you must either twist your foot outwards or to the rear to “get out of the pedals”.
The most conventional click pedal systems are:
Pedal system for mountain bikes from Shimano
Pedal system for road bikes from Shimano
Road bike system from Shimano with a wider contact surfaceBild 1
Manufacturer of road and mountain bike click pedal systems
Developed the first click pedal system for bikes in 1984 which was based on systems from skis.
Manufacturer of the dirt resistant Egg Beater click pedal system
Please observe the following:
• Cleats wear out relatively quickly and must be regularly replaced.
• Cleats can cause noises. Assembly grease can remedy such problems.
• Use only the cleats supplied with your new shoes by the manufacturer.
Ensure that all screws and bolts are tightened to the correct torque. The correct torque is indicated on the component itself, in the bike manual provided with your new bike, or here in the Technical Support Center.
Canyon streeft voortdurend naar behoud van kwaliteit en nauwkeurigheid van de informatie die zich bevindt in het Technical Support Center. Reparaties of aanpassingen die je aan je eigen fiets doet zijn volledig op eigen risico. Als je twijfelt over wat te doen, kun je het beste contact op nemen met het Canyon Servicecentrum. Canyon geeft geen garantie en accepteert geen aansprakelijkheid voor de informatie die zich bevindt in het Technical Support Center.