Unfortunately, we do not ship to your country.



Please contact our Servicecenter. We are available today until 19:00 CET: +49 261 40 4000
Difficulty: hard
These workshops are intended for experienced and skilled mechanics, who have extensive experience with sports cycles. Jobs in this category mostly require tools which need expertise to operate such as the chain whip, torque spanner or pedal spanner.
Tools: Similar Topics: Print Article

Replacing of rear derailleur hanger Mountainbike

The rear derailleur is the most exposed part on the bicycle. If force is applied to this part, the bike frame or the rear derailleur could be damaged. To prevent damage on these expensive parts, the rear derailleur is connected to the frame with a rear derailleur hanger. If lateral force is applied to the rear derailleur, for example by a fall or during transport, it absorbs the force and protects the frame and the rear derailleur from damage. In this case it breaks or bends.

A bent or broken rear derailleur hanger needs to be changed.

Hint: Check from time to time if the rear derailleur hanger is not bent. In many cases a bent derailleur hanger results in a malfunctioning rear derailleur.

1. Check the rear derailleur hanger as follows: Lean the bicycle on a wall and look at the hanger from behind. The cage of the rear derailleur hanger should be positioned plumb-vertical to the sprockets.
Picture 1

2. If the hanger is bent or broken, you need to change it. Firstly, unscrew the rear derailleur. Picture 2

3. The hanger is attached to the frame with two small allen screws, of either 2mm or 2,5mm.Picture 3

4. You can attach the new hanger in the same way. Always mind the correct torque. Picture 4

Apply grease to the hanger to avoid creaking sounds.

Mounting of rear derailleur hangers, model year 2015, for Nerve CF Serie (except Nerve AL29), all Strive models, all Spectral models, all Dude CF models and the Grand Canyon CF 5.9

1. Grease the assembly area Picture 5

2. Mount the plate from outside Picture 6

3. Mount the hanger Picture 7

4. Screw together both parts. Tighten the screw with 3Nm. Picture 8

5.Grease the thread of the derailleur hanger and mount it. Picture 9

Ensure that all bolts and screws are tightened to the correct torque. The correct torque is indicated on the component itself, in the bike manual provided with your new bike, or here in the Technical Support Center.

Canyon consistently strives to ensure the quality and accuracy of the information contained in this Technical Support Center. Any repairs or adjustments which you carry out on your bike are entirely at your own risk. If you are in any doubt about what to do, you should send your bike to Canyon or take it to another qualified repair specialist. Canyon gives no guarantee or accepts no liability for the any of the information contained in this Technical Support Center.

Picture 1: Check, if the derailleur hanger is bended

Picture 1: Check, if the derailleur hanger is bended

Picture 2: Dismantle the rear derailleur

Picture 2: Dismantle the rear derailleur

Picture 3: Undo the screw

Picture 3: Undo the screw

Picture 4: Tighten the screw

Picture 4: Tighten the screw

Did this article help you?yesno

Pure Cycling.